IBM USB
Portable CD-ROM Drive
User's Guide
Contents
Registering your option
. . . . . . . . . . . . . . . . . . . . . . . . . . . . iv
About this book
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . iv
Part 1: Installation and usage guide . . . . . . . . . . . . . . . . 1-1
Part 2: Appendixes . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Appendix A. Help and service information . . . . . . . . . . . . . . . . . 2-1
Online technical support . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Telephone technical support . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Appendix B. Product warranties and notices . . . . . . . . . . . . . . . . 2-2
Warranty Statements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2
Notices
Trademarks
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-11
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-11
Electronic emission notices
Japanese statement of compliance for products less than or equal to 20 A per
phase . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-15
. . . . . . . . . . . . . . . . . . . . . . . . . . 2-12
Copyright IBM Corp. 2000
iii
Registering your option
Thank you for purchasing this IBM product. Please take a few moments to register
your product and provide us with information that will help IBM to better serve you in
the future. Your feedback is valuable to us in developing products and services that
are important to you, as well as in developing better ways to communicate with you.
Register your option on the IBM Web site at:
IBM will send you information and updates on your registered product unless you
indicate on the Web site questionnaire that you do not want to receive further
information.
About this book
This manual contains instructions for installing and using your IBM USB Portable
CD-ROM Drive. The manual is divided into two parts:
Part 1:
Installation and usage guide
This section contains the product description, installation instructions, and
usage information in the following languages:
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
English
German
French
Spanish
Italian
Brazilian Portuguese
Japanese
Part 2:
Appendixes
This section contains help and service information, the product warranties,
and notices.
Note: The illustrations in this manual might be slightly different from your hardware.
iv USB Portable CD-ROM Drive
Part 1: Installation and usage guide
This guide contains the product description, installation instructions, and product use
information.
Product description
The IBM USB Portable CD-ROM Drive is a slimline CD-ROM drive that attaches
quickly and conveniently to your IBM ThinkPad computer through one simple
connection.
In addition to this book, the option package includes:
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
IBM USB Portable CD-ROM Drive
USB cable
Audio cable
Carrying case
IBM USB Portable CD-ROM Drive Option Diskette
Laser Safety Guide for CD-ROMs
Hardware and software requirements
You must have the following hardware included on your IBM ThinkPad computer in
order to use this option:
ꢀ
ꢀ
An available USB port
A USB Universal Host Controller Interface (UHCI) Controller
Note: To determine what type of USB Controller is included on your computer,
follow these steps.
1. Click Start → Settings → Control Panel.
2. Double-click System.
3. Click the Device Manager tab.
4. In the list of devices, click Universal Serial Bus Controller.
5. Confirm whether the controller type is UHCI or another type.
Your computer must have one of the following operating systems to use this option:
ꢀ
ꢀ
Microsoft Windows 98
Microsoft Windows 2000 Professional
Copyright IBM Corp. 2000
1-1
Front view of the drive
Refer to the following illustration to locate controls.
ꢀ1ꢁBusy indicator
This green light glows steadily when the power is turned on
and blinks when the drive is active.
ꢀ2ꢁStop button
Use this to stop playback of an audio CD (for details on
using the audio control buttons, see “Using the CD-ROM
drive audio player functions” on page 1-4).
ꢀ3ꢁPlay button
Use this to begin playback of an audio CD (for details on
using the audio control buttons, see “Using the CD-ROM
drive audio player functions” on page 1-4).
Rear view of the drive
Refer to the following illustration to locate controls and connectors.
ꢀ1ꢁCover release
Pull this forward to open the CD-ROM drive cover and
load a CD.
ꢀ2ꢁVolume control
Use this to adjust the volume output to your headphones or
speakers.
ꢀ3ꢁAudio output jack
ꢀ4ꢁUSB connector
Plug in headphones or the included audio cable here.
Plug the USB cable into this connector.
1-2 USB Portable CD-ROM Drive
Connecting the CD-ROM drive to your
computer
Follow these instructions to connect the CD-ROM drive.
1. Locate the USB cable included with this option. One connector on the USB
cable is smaller than the other and has two small buttons on each side of it.
2. Squeeze the two buttons on the smaller connector and attach that end of the USB
cable to the USB connector on the back of the CD-ROM drive, as shown below.
Make sure that the metal plate on the smaller connector is facing up when you
plug it into the USB connector on the CD-ROM drive.
3. Plug the larger end of the USB cable into the USB port on your computer.
4. You can plug a set of headphones into the audio output jack (see ꢀ3ꢁ in the rear
view illustration on page 1-2) in order to listen to audio CDs. Alternatively, if
you want to listen to audio on your ThinkPad speakers, plug one end of the
included audio cable into the audio output jack on the CD-ROM drive, and plug
the other end of the audio cable into either the microphone jack or the line-in jack
on your ThinkPad computer. This will route the audio to your ThinkPad
speakers.
Installing the device driver
To install the device driver, follow the instructions that correspond to your operating
system.
Part 1: Installation and usage guide 1-3
Windows 98
Follow these instructions to install the device driver for Windows 98.
1. After you have attached the CD-ROM drive to your computer, turn on your
computer if it is not turned on already.
2. In the New Hardware Wizard for IBM USB Portable CD-ROM Drive window,
click Next.
3. Click to select the Search for the best driver for your device check box.
4. Insert the IBM USB Portable CD-ROM Drive Option Diskette into your diskette
drive.
5. Click to select the Floppy disk drive check box.
6. Click Next twice.
7. Click Finish to complete the device driver installation.
You can now use the CD-ROM drive with Windows 98.
Windows 2000
The Windows 2000 operating system includes a USB device driver. The operating
system recognizes the CD-ROM drive as soon as it is attached and uses the correct
device driver. The device driver included on the IBM USB Portable CD-ROM Drive
Option Diskette is not required for Windows 2000.
Using the CD-ROM drive audio player
functions
There are two ways to use the CD-ROM drive to play audio CDs. You can use the
Microsoft Windows CD Player, with which you can control the CD playback on your
computer screen. You can also use the two audio control buttons on the front of the
CD-ROM drive.
Note: You must close the Microsoft Windows CD Player in order to use the control
buttons on the front of the CD-ROM drive. The buttons will not work while the
Microsoft Windows CD Player is running.
Although there are only two control buttons on the front of the CD-ROM drive, you
can use those two buttons to perform all the major functions of a normal CD player.
Refer to the following table to determine what sequence of actions you need to take in
order to perform each function.
1-4 USB Portable CD-ROM Drive
To perform this function:
Do this:
Play
When an audio CD is first loaded, push the Play
button to initiate playback from the beginning of
the first track.
Pause
When an audio CD is playing, push the Stop
button to pause playback. After pausing, push the
Play button to resume playback from the same
position.
Note: After 32 seconds in Pause, the CD-ROM
drive will enter Standby mode to conserve
power.
Stop
Push the Stop button twice to stop playback.
Note: If you begin playback after pushing the
Stop button twice, playback will begin at
the first track again.
Next Track
While the CD is playing, push the Play button
once.
Previous Track
If the current track has been playing less than 10
seconds, press and hold the Play button for 2.5
seconds and then release.
Return to Start of Current Track
Random Track Selection
If the current track has been playing more than 10
seconds, press and hold the Play button for 2.5
seconds and then release.
Press and hold the Play and Stop buttons together
for more than one second while the CD is playing.
To return to sequential play, push the Stop button.
Uninstalling the Windows 98 device driver
If you have installed the Windows 98 device driver and need to uninstall it, follow
these instructions.
1. Insert the IBM USB Portable CD-ROM Drive Option Diskette into the diskette
drive.
2. Click Start.
3. Select Run.
4. Click Browse.
5. From the Look in menu, click 3 1/2 Floppy (A:).
6. Double-click UnUsbdrv.exe.
7. Click Yes to confirm uninstallation.
8. Click Yes to restart your computer.
Part 1: Installation and usage guide 1-5
The device driver is now uninstalled. Your computer will not recognize the CD-ROM
drive when it is connected to the computer unless you reinstall the device driver.
Disconnecting and reconnecting the CD-ROM
drive
Hot plugging is supported on the connection between the USB cable and your
computer. This means that the CD-ROM drive USB cable can be disconnected from
and reconnected to your computer whether the computer is on or off.
Attention
The connection between the USB cable and the CD-ROM drive itself does not
support hot plugging. If you disconnect the USB cable from the CD-ROM drive
while the USB cable is attached to your computer, it might cause damage to the
CD-ROM drive.
To avoid damaging the CD-ROM drive, turn off the CD-ROM drive before
disconnecting the USB cable from your computer. To disconnect the CD-ROM drive
from the computer, unplug the USB cable from the computer. To reconnect the
CD-ROM drive, reconnect the USB cable to the computer.
Attention
Do not disconnect and reconnect the USB cable in rapid succession or the
CD-ROM drive might not load properly. After disconnecting the USB cable, wait
at least 10 to 20 seconds, or until the hourglass icon stops displaying, before
reconnecting the USB cable.
1-6 USB Portable CD-ROM Drive
|