47570 Rev 1 25/6/04 4:57 PM Page 1
Pump action espresso coffee maker
Please read and keep these instructions
getting the best from your
new coffee maker
• Safety first
Caution must be used when handling hot water, coffee or steam.
• Run water through your machine before
first use
It is important to run water through your coffee maker in order to
rinse the machine. You can also run water through to warm your
coffee machine.
• Descale as appropriate for the hardness of the
water in your area
It is important to descale as the performance of your coffee
maker may be impaired by limescale and other impurities in the
water supply.
47570 Rev 1 25/6/04 4:57 PM Page 3
WARNING : The plug removed from
the mains lead, if severed, must be
destroyed as a plug with bared flexible
cord is hazardous if engaged into a
live socket outlet.
Should the fuse in the 13 amp plug
require changing a 13 amp BS1362 fuse
must be fitted.
Electrical requirements
Check that the voltage on the rating
plate of your appliance corresponds with
your house electricity supply which must be
A.C. (Alternating current).
For appliances with fitted plug.
If the socket outlets in your home are not
suitable for the plug supplied with this
appliance the plug should be removed and
the appropriate one fitted.
WARNING: This appliance must be
earthed.
Features
⁄ Cup tray
¤ Warm up light
‹ Power light
› Coffee selector
fi On/off switch
fl Steam selector
‡ Filter holder
· Non slip rubber feet
‚ Filter
„ Measuring spoon
‰ Compactor
Í
È
⁄
¤
Ë
Á
›
‹
fi
fl
 Removable drip tray
Ê Steam nozzle
Á Removable water tank
Ë Steam valve
Ê
‡
È Steam light
Í Spoon storage
Â
‰
·
„
‚
3
47570 Rev 1 25/6/04 4:57 PM Page 4
Before first use
Operating your coffee
maker
1 Plug the unit into the power outlet.
2 Switch the unit on by pressing the on/off
switch fi. The ‘power light’ ‹ and
‘warm up light’ ¤ will illuminate.
3 Select the filter ‚ and place in the filter
holder ‡. D
Before using your coffee maker for the
first time or if you have not used it for some
time, rinse the machine by running water
through. Follow the procedure for making
espresso coffee below, without coffee in the
filter holder.
Espresso operation
E
D
Filling the water tank
1 Open the water tank Á by sliding the
tank sideways using the ribs and remove
to fill. A
IMPORTANT: Do not overfill or carry
when full.
4 Using your measuring spoon „
supplied, measure 1 spoon for one cup
and 2 spoons for 2 cups of ground
coffee into the filter. With the other end
of the measuring spoon, use the
compactor ‰ to tamp down the
coffee. E
A
IMPORTANT: Be sure not to overfill the
filter with too much coffee, and wipe around
the edge of the filter to remove any coffee
grounds.
5 Place the filter holder ‡ on the brewing
head and position the handle so it points
to the left. F
WARNING: Do not fill through the
top lid, only fill the tank itself.
2 Fill the water tank Á using cold tap
water. B
3 Replace the water tank by sliding it back
into place. C
Ensure the filter holder is flat against the
brewing head and turn the handle
towards the right G as far as it will go.
Note: Do not overtighten.
B
C
G
F
IMPORTANT: Ensure the tank is pushed
firmly into place or the water will not flow.
•
Hint - The spoon can be stored in the
drawer Í after use.
4
47570 Rev 1 25/6/04 4:57 PM Page 5
6 For brewing 2 cups, place the cups
under each of the holes in the filter, for
brewing 1 cup only, place the cup
centrally on the drip tray. H. When the
coffee maker is at the correct
temperature the ‘warm up light’ will go
out ¤.
IMPORTANT: For the froth enhancing
attachment to work you must ensure that it
is pushed firmly onto the steam nozzle.
2 Fill the water tank with cold tap water.
3 Turn the unit on. The ‘power light’ and
‘warm up light’ will both illuminate.
4 Swing the steam nozzle with the froth
attachment to the side of the machine.
5 Pour cold milk into a suitable jug. Use
approximately 100ml for each
H
cappuccino.
Note: For best results we recommend to
use refridgerated milk and a stainless steel
jug that is well chilled.
6 Press the steam button fl. The steam
ligth È will illuminate and stay lit whilst
the unit is in steam mode.
7 When the unit is the right temperature
the ‘warm up light’ will go out.
7 Press the coffee selector button ›. You
will hear the machine make a pumping
noise, this is normal.
8 Once the cups are filled to the desired
level press the coffee selector button.
Water will still filter through for a few
seconds after the machine has been
switched off.
8 Hold the jug under the steam nozzle so
that the head of the froth attachment is
immersed in the milk. K
K
WARNING: Never remove the filter
holder when water is running through
it.
9 Remove the filter holder and filter by
turning the filter holder handle to the left.
10To the remove the used coffee grounds
from the filter, turn the filter holder
upside down. Gently tap out the
coffee. I
9 Turn the steam control dial towards the
steam symbol . You will hear the
machine make a pumping noise, this is
normal.
I
J
IMPORTANT: Do not allow the tip of the
nozzle to touch the bottom of the jug
because this could obstruct the passage of
steam.
10Once the froth has been produced, turn
the steam control dial towards and
remove the jug.
11Once the orange ‘warm up light’ goes
out your machine is ready to make the
next espresso.
Note: Do not be alarmed by the
escaping steam from the base.
11The milk is ready as soon as it forms a
thick layer of foam on the top. If the milk
starts to make large popping bubbles,
you have boiled the milk and it will
therefore not froth. If this happens
replace with the chilled milk. Do not boil
the milk.
Steam function
The froth attachment makes it easy to
produce frothy milk for cappuccino.
1 Attach the froth attachment to the end of
the steam nozzle. J
5
47570 Rev 1 25/6/04 4:57 PM Page 6
Frothing tips
Cleaning and
maintenance
You must clean the steam nozzle and
froth attachment immediately after each
use.
•
•
•
For best results use fresh, cold milk from
the refrigerator.
Skimmed milk or fat reduced milk will
make frothing easier.
Use a stainless steel jug.
Hot water drinks
1 Simply wipe the steam nozzle, cup tray
and exterior with a clean, damp cloth.
Do not use any abrasives or metal
scourers as this will damage the finish
on the unit.
You are able to make hot water drinks
such as tea or instant soups using the
steam nozzle.
1 Ensure the unit is cold before removing
the froth attachment from the steam
nozzle if attached.
2 Follow the ‘steam function’ and heat up
hot water instead of milk.
Note: It is normal for the orange ‘warm
up light’ to cycle on and off during the
water heat up process.
2 Briefly run steam through the nozzle
(follow the directions under ‘steam
function’, to clear any remaining milk out
of the steam nozzle.
WARNING: Steam from the nozzle is
extremely hot and can scald.
3 Place the froth attachment under running
water to remove any excess milk.
4 The filter, filter holder and water tank
should be washed after each use by
rinsing them under warm water. To assist
in keeping the filters clean we
Preheating the coffee
maker
To make hotter coffee you may preheat
our machine. This can be achieved by
following the ‘espresso operation’ by
passing water through the coffee maker but
without using coffee.
recommend you periodically run the
machine with the filter in place, without
coffee, using water only.
5 Lift out the drip tray and wash under the
tap. Ensure it is dry before refitting. L
•
Never use warm or hot water to fill the
water tank.
L
Should the holes in the filters become
blocked with coffee granules use a fine
bristled brush.
When your coffee maker is not being
used, we recommend that you do not leave
the filter holder attached to the machine as
this will reduce the life of the gasket.
NO PARTS ARE SUITABLE FOR
CLEANING IN A DISHWASHER.
6
47570 Rev 1 25/6/04 4:57 PM Page 7
Descaling
Helpline
If you live in a hard water area, we
recommend that your coffee maker is
descaled at regular intervals, e.g. every 2-3
months. In areas of moderately hard water
you should descale every 6 months. If the
water filters through more slowly than usual,
it is a sign that descaling is necessary.
We recommend you use proprietary
liquid descaler which is especially made for
coffee makers and plastic kettles.
If you have any difficulty with your
appliance, do not hesitate to call us.
We are more likely able to help than the
store from where you bought it.
Please have the following information
ready to enable our staff to deal with your
query quickly.
•
•
Name of the product
Model number and serial as shown on
the underside of the appliance.
Follow the instructions on the bottle,
then operate the coffee maker with clean
water 3 times before making coffee again.
IMPORTANT: Ensure the descaler is
suitable for coffee makers.
7
47570 Rev 1 25/6/04 4:57 PM Page 8
the manufacturers instructions. For example
coffee makers should have been regularly
descaled.
Your two year guarantee
It is important to retain the retailers receipt
as proof of purchase. Staple your receipt to this
back cover for future reference.
Please quote the following information if the
product develops a fault. These numbers can
be found on the base of the product.
EXCLUSIONS
Morphy Richards shall not be liable to
replace or repair the goods under the terms of
the guarantee where:
1
The fault has been caused or is attributable
to accidental use, misuse, negligent use or
used contrary to the manufacturers
recommendations or where the fault has
been caused by power surges or damage
caused in transit.
Model no.
Serial no.
All Morphy Richards products are
individually tested before leaving the factory. In
the unlikely event of any appliance proving to be
faulty within 28 days of purchase it should be
returned to the place of purchase for it to be
replaced.
If the fault develops after 28 days and within
24 months of original purchase, you should
contact the Helpline number quoting Model
number and Serial number on the product, or
write to Morphy Richards at the address shown.
You will be asked to return the product (in
secure, adequate packaging) to the address
below along with a copy of proof of purchase.
Subject to the exclusions set out below (see
Exclusions) the faulty appliance will then be
repaired or replaced and dispatched usually
within 7 working days of receipt.
2
3
The appliance has been used on a voltage
supply other than that stamped on the
products.
Repairs have been attempted by persons
other than our service staff (or authorised
dealer).
4
5
Where the appliance has been used for hire
purposes or non domestic use.
Morphy Richards are not liable to carry out
any type of servicing work, under the
guarantee.
6
Plastic filters for all Morphy Richards kettles
and coffee makers are not covered by the
guarantee.
If for any reason this item is replaced during
the 2 year guarantee period, the guarantee on
the new item will be calculated from original
purchase date. Therefore it is vital to retain your
original till receipt or invoice to indicate the date
of initial purchase.
This guarantee does not confer any rights
other than those expressly set out above and
does not cover any claims for consequential
loss or damage. This guarantee is offered as an
additional benefit and does not affect your
statutory rights as a consumer.
To qualify for the 2 year guarantee the
appliance must have been used according to
•
This guarantee is valid in the UK and Ireland
only.
Morphy Richards products are intended for
household use only.
The After Sales Division
Registered address
Morphy Richards Ltd, Mexborough
South Yorkshire, England, S64 8AJ
Morphy Richards has a policy of continuous
improvement in product quality and design.
The company, therefore reserves the right
to change the specification of its models at
any time.
Helpline (office hours)
UK 0870 060 2610
Republic of Ireland 1800 409119
CM47570M UK Rev 1 0604
|